轴系方面求助

导缆钳 · 发表于 2012-2-22 19:31

“Requiement of slop boring can be decided only after the shaft alignment calculations.Slope boring or bearing inclination is to be considered when calculated misalignment between the shaft and the Bearing'centre line is greater than 0.3mrad.”中的“slope boring”和“bearing inclination”到底是什么东西，作什么用，轴系计算什么时候做，怎么做的？烦望各位大侠相助，急

高先生 · 发表于 2012-3-30 16:37

是轴系较中计算时，如果艉轴和艉轴承的相对偏中超过0.3mrad时需要对轴承进行斜镗孔！
relative nominal slope between shaft and aft sterntube
white metal lined bearing should, in general, not exceed
3·10-4 rad (0.3 mm/m) and 50% of min. diametrical bearing
clearance divided by the bearing length, whichever is
less (otherwise to be compensated with slope bore). For
other lining metals or rubber, reinforced resins, etc., the
limit for relative nominal slope shall be especially considered

[轮机] 轴系方面求助