|
|
5.5.1.2 Slots are to be well-rounded and have a minimum slot length, lslot, of 75mm and
width, wslot, of twice the gross plate thickness. Where used in the body of doublers
and similar locations, such welds are in general to be spaced a distance, sslot, of 2lslot
to 3lslot but not greater than 250mm.
5.5.2.2 Slots are to be well rounded and have a minimum slot length, lslot, of 90mm and a
minimum width, wslot, of twice the gross plate thickness. Slots cut in plating are to
have smooth, clean and square edges and are in general to be spaced a distance, sslot,
not greater than 140mm. Slots are not to be filled with welding.
请大家分析下这两段话 槽焊 到底是怎么定义的是： 长度75mm 宽度为 腹板板厚的两倍 最大间距不得大于250mm
长度90mm 宽度为 腹板板厚的两倍 最大间距不得大于140mm
到底哪个是正确的 这是我在CSR 上看到的
看看大家的意见 |
|
发表于 2010-11-9 09:32
提升卡
变色卡
