|
|
RULES FOR
MATERIALS AND WELDING
2007
PART 2
Rule Change Notice (2007)
The effective date of each technical change since 1993 is shown in parenthesis at the end of the
subsection/paragraph titles within the text of each Part. This date is based on the date of purchase
order of the materials. Unless a particular date and month are shown, the years in parentheses refer to
the following effective dates:
(2000) and after 1 January 2000 (and subsequent years) (1996) 9 May 1996
(1999) 12 May 1999 (1995) 15 May 1995
(1998) 13 May 1998 (1994) 9 May 1994
(1997) 19 May 1997 (1993) 11 May 1993
Listing by Effective Dates of Changes from the 2006 Rules
EFFECTIVE DATE 1 January 2007
(based on the date of purchase order of the materials)
Part/Para. No. Title/Subject Status/Remarks
2-1-1/17 Steel Plates and Wide Flats with
Specified Minimum Through
Thickness Properties (“Z” Quality)
To clarify that ASTM A 770 is not to be primarily used for reduction
of area, ultrasonic testing and marking.
2-1-1/17.11 Ultrasonic Inspection To clarify the frequency to be used for this type of ultrasonic testing.
2-1-2/9.7 Elongation Deduction for Material
Under 7.9 mm (0.313 in.) Thick
To remove a conflict with the application of 2-1-2/Table 3 and
2-1-3/Table 3.
2-2-1/1
(New)
General Requirements To maintain consistency with IACS UR W29.
2-2-1/3
(New)
Materials for Anchors To maintain consistency with IACS UR W29.
2-2-1/5
(New)
Manufacture of Anchors To maintain consistency with IACS UR W29.
2-2-1/Figure 1
(New)
Allowable Lateral Movement of
Shank
To maintain consistency with IACS UR W29.
2-2-1/7 Testing and Certification To maintain consistency with IACS UR W29.
2-2-1/Table 1
(New)
Applicable Test Programs for Each
Product Form
To maintain consistency with IACS UR W29.
2-2-1/Table 2
(New)
Product Test Requirements for
Program A and B
To maintain consistency with IACS UR W29.
2-2-1/Table 3
(New)
General NDE for Ordinary and SHP
Anchors
To maintain consistency with IACS UR W29.
2-2-1/Table 4
(New)
General NDE For SHP Anchors For
Restricted Service with 4 Times the
Holding Power of Ordinary Anchors
To maintain consistency with IACS UR W29.
2-2-1/Table 5
(New)
Extended NDE for Ordinary and All
SHP Anchors
To maintain consistency with IACS UR W29.
2-2-1/11
(New)
Certification To maintain consistency with IACS UR W29.
2-2-1/13
(New)
Painting To maintain consistency with IACS UR W29.
2-3-1/1.1 General To clarify that the Surveyor does not necessarily carry out tests and
inspections, but does need to verify that materials are tested and
inspected.
Part_2_e-Jun07.part1.rar
(976.56 KB, 下载次数: 286)
Part_2_e-Jun07.part2.rar
(885.62 KB, 下载次数: 249)
|
|
发表于 2007-12-24 13:30
提升卡
变色卡
