求助CUTOUT定义文件

lbf_2000 · 发表于 2007-4-18 19:03

For cutouts with a lug on one side and quite open on the other, giving option
/FL_WIDTH means that these clearances are set to B -S +<xxx>. (Here, B is the width of the flange and S the thickness of the web and <xxx> the given value).
This will normally result in a cutout with total width between the lug and the opposite side equal to B+<xxx>. It is especially useful when T-bars should be inserted as described in the figure below and should be used only for cutouts with lug one side.

lbf_2000 · 发表于 2007-4-18 19:05

For cutouts with a lug on one side and quite open on the other, giving option
/FL_WIDTH means that these clearances are set to B -S +<xxx>. (Here, B is the width of the flange and S the thickness of the web and <xxx> the given value).
This will normally result in a cutout with total width between the lug and the opposite side equal to B+<xxx>. It is especially useful when T-bars should be inserted as described in the figure below and should be used only for cutouts with lug one side.

/FL_WIDTH =B+100 为什么不对???

xupeng120 · 发表于 2007-4-20 16:16

设置 FL_WIDTH=B-S+X B是面板宽度 S是腹板厚度 X是设定值这种情况用于贯穿孔的补板到对应的边的宽度=B+X时

lbf_2000 · 发表于 2007-4-21 00:16

但这样定义为什么会过不去啊

lbf_2000 · 发表于 2007-4-18 14:25

在定义T型材CUTOUT 时,/FL_WIDTH 语句怎么用??谢谢

sws1029 · 发表于 2007-6-3 17:00

simon21 · 发表于 2007-6-24 18:32

ding!!!!!!!!!!!!!!!

jiewen27296 · 发表于 2014-2-21 14:03

顶一个！！！！

】KODOMO【 · 发表于 2014-2-22 11:06

想弄个软件来自己学学~真心的好麻烦好麻烦！！！
我想找个试用版都觉得很麻烦！

[其他] 求助CUTOUT定义文件